[U-Boot] [PATCH v2] at91: add at91sam9xeek board support

Nicolas Ferre
2009-01-05T14:42:26Z

At91sam9xe is basically an at91sam9260 with embedded flash. We can manage
it as another entry for at91sam9260 in the Makefile.

Check documentation at :
http://www.atmel.com/dyn/products/product_card.asp?part_id=4263

Signed-off-by: Nicolas Ferre <nicolas.ferre@atmel.com>
---
Patch against u-boot-at91.git

V2 integrates the typo noted during
the v1 review (Typo: CFG_ convert to CONFIG_SYS_)

Makefile | 17 +++++++++++++++++
1 files changed, 17 insertions(+), 0 deletions(-)

diff --git a/Makefile b/Makefile
index 623b8f7..74dfcca 100644
--- a/Makefile
+++ b/Makefile
@@ -2599,6 +2599,23 @@ at91sam9260ek_config : unconfig
fi;
@$(MKCONFIG) -a at91sam9260ek arm arm926ejs at91sam9260ek atmel at91

+at91sam9xeek_nandflash_config \
+at91sam9xeek_dataflash_cs0_config \
+at91sam9xeek_dataflash_cs1_config \
+at91sam9xeek_config : unconfig
+ @mkdir -p $(obj)include
+ @if [ "$(findstring _nandflash,$@)" ] ; then \
+ echo "#define CONFIG_SYS_USE_NANDFLASH 1" >>$(obj)include/config.h ; \
+ $(XECHO) "... with environment variable in NAND FLASH" ; \
+ elif [ "$(findstring dataflash_cs0,$@)" ] ; then \
+ echo "#define CONFIG_SYS_USE_DATAFLASH_CS0 1" >>$(obj)include/config.h ; \
+ $(XECHO) "... with environment variable in SPI DATAFLASH CS0" ; \
+ else \
+ echo "#define CONFIG_SYS_USE_DATAFLASH_CS1 1" >>$(obj)include/config.h ; \
+ $(XECHO) "... with environment variable in SPI DATAFLASH CS1" ; \
+ fi;
+ @$(MKCONFIG) -n at91sam9xeek -a at91sam9260ek arm arm926ejs at91sam9260ek atmel at91sam9
+
at91sam9261ek_nandflash_config \
at91sam9261ek_dataflash_cs0_config \
at91sam9261ek_dataflash_cs3_config \
--
1.5.3.7