[U-Boot] [PATCH 5/9] ARM: remove unused variable

[Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>]

On 23:20 Wed 04 Feb     , Guennadi Liakhovetski wrote:
> On Wed, 4 Feb 2009, Jean-Christophe PLAGNIOL-VILLARD wrote:
> 
> > On 17:59 Wed 04 Feb     , Guennadi Liakhovetski wrote:
> > > The "size" variable in start_armboot() in lib_arm/board.c is only really 
> > > used in
> > > #if !defined(CONFIG_SYS_NO_FLASH)
> > > case, remove where unused.
> > > 
> > why not remove it
> > in the CONFIG_SYS_NO_FLASH you can not use it at all
> 
why not do this

Best Regards,
J.
---
diff --git a/lib_arm/board.c b/lib_arm/board.c
index 2358beb..9afd15f 100644
--- a/lib_arm/board.c
+++ b/lib_arm/board.c
@@ -275,9 +275,6 @@ void start_armboot (void)
 {
 	init_fnc_t **init_fnc_ptr;
 	char *s;
-#if !defined(CONFIG_SYS_NO_FLASH) || defined (CONFIG_VFD) || defined(CONFIG_LCD)
-	ulong size;
-#endif
 #if defined(CONFIG_VFD) || defined(CONFIG_LCD)
 	unsigned long addr;
 #endif
@@ -303,8 +300,7 @@ void start_armboot (void)
 
 #ifndef CONFIG_SYS_NO_FLASH
 	/* configure available FLASH banks */
-	size = flash_init ();
-	display_flash_config (size);
+	display_flash_config (flash_init ());
 #endif /* CONFIG_SYS_NO_FLASH */
 
 #ifdef CONFIG_VFD
@@ -316,7 +312,7 @@ void start_armboot (void)
 	 */
 	/* bss_end is defined in the board-specific linker script */
 	addr = (_bss_end + (PAGE_SIZE - 1)) & ~(PAGE_SIZE - 1);
-	size = vfd_setmem (addr);
+	vfd_setmem (addr);
 	gd->fb_base = addr;
 #endif /* CONFIG_VFD */
 
@@ -331,7 +327,7 @@ void start_armboot (void)
 		 */
 		/* bss_end is defined in the board-specific linker script */
 		addr = (_bss_end + (PAGE_SIZE - 1)) & ~(PAGE_SIZE - 1);
-		size = lcd_setmem (addr);
+		lcd_setmem (addr);
 		gd->fb_base = addr;
 	}
 #endif /* CONFIG_LCD */