[U-Boot] tftp not working

Afzal Nadirshah
2009-02-17T12:24:08Z

Hi All,
The issue has been resolved.
I built the u-boot-nand.bin image from the u-boot cource code obtained from the AMCC site.
With this image tftp is working fine,once i set the ethaddr,serverip and ipaddr.
Initially i was working with the latest u-boot source code from the denx site.I found out that there was some differences between these two versions.For example the lates u-boot source code does not contain the file /drivers/net/4xx_enet.c while the one from AMCC site contains the same.
Thanks.

Regards,
Afzal Nadirshah
________________________________________
From: Stefan Roese [sr at denx.de]
Sent: Monday, February 16, 2009 2:45 PM
To: Afzal Nadirshah
Cc: u-boot at lists.denx.de; Wolfgang Denk
Subject: Re: [U-Boot] tftp not working

On Monday 16 February 2009, Afzal Nadirshah wrote:
> I did as suggested by you. I also set the serverip as well as ipaddr. Now
> when i do a tftp 100000 u-boot-nand.bin, i get the following :
>
> => tftp 100000 u-boot-nand.bin
> Waiting for PHY auto negotiation to complete...... TIMEOUT !

!!!

> done
> ENET Speed is 10 Mbps - HALF duplex connection (EMAC0)
> Using ppc_4xx_eth0 device
> TFTP from server 172.22.68.33; our IP address is 172.22.68.36
> Filename 'u-boot-nand.bin'.
> Load address: 0x100000
> Loading: *
>
> It hangs at this point

Your board doesn't have a correct ethernet link. Is this really the original
Canyonlands board? Is the correct ethernet port connected?