[U-Boot] [PATCH 1/7] mpc83xx: MPC837XEMDS: Initialize SerDes before negating PCIE reset signal

[Anton Vorontsov <avorontsov@ru.mvista.com>]

The SerDes initialization should be finished before negating the reset
signal according to the reference manual. This isn't an issue on real
hardware, but we'd better stick to the specifications anyway.

Suggested-by: Liu Dave <DaveLiu@freescale.com>
Signed-off-by: Anton Vorontsov <avorontsov@ru.mvista.com>
---
 board/freescale/mpc837xemds/pci.c |   14 +++++++-------
 1 files changed, 7 insertions(+), 7 deletions(-)

diff --git a/board/freescale/mpc837xemds/pci.c b/board/freescale/mpc837xemds/pci.c
index 31116b3..29de2e7 100644
--- a/board/freescale/mpc837xemds/pci.c
+++ b/board/freescale/mpc837xemds/pci.c
@@ -115,6 +115,13 @@ skip_pci:
 	if (PARTID_NO_E(spridr) == SPR_8379)
 		return;
 
+	if (pex2)
+		fsl_setup_serdes(CONFIG_FSL_SERDES2, FSL_SERDES_PROTO_PEX_X2,
+				 FSL_SERDES_CLK_100, FSL_SERDES_VDD_1V);
+	else
+		fsl_setup_serdes(CONFIG_FSL_SERDES2, FSL_SERDES_PROTO_PEX,
+				 FSL_SERDES_CLK_100, FSL_SERDES_VDD_1V);
+
 	/* Configure the clock for PCIE controller */
 	clrsetbits_be32(&clk->sccr, SCCR_PCIEXP1CM | SCCR_PCIEXP2CM,
 				    SCCR_PCIEXP1CM_1 | SCCR_PCIEXP2CM_1);
@@ -132,13 +139,6 @@ skip_pci:
 	out_be32(&pcie_law[1].bar, CONFIG_SYS_PCIE2_BASE & LAWBAR_BAR);
 	out_be32(&pcie_law[1].ar, LBLAWAR_EN | LBLAWAR_512MB);
 
-	if (pex2)
-		fsl_setup_serdes(CONFIG_FSL_SERDES2, FSL_SERDES_PROTO_PEX_X2,
-				 FSL_SERDES_CLK_100, FSL_SERDES_VDD_1V);
-	else
-		fsl_setup_serdes(CONFIG_FSL_SERDES2, FSL_SERDES_PROTO_PEX,
-				 FSL_SERDES_CLK_100, FSL_SERDES_VDD_1V);
-
 	mpc83xx_pcie_init(pex2 ? 1 : 2, pcie_reg, 0);
 }
 
-- 
1.5.6.5