[U-Boot] [PATCH u-boot git] dm9000 EEPROM reading bugfix

[David Brownell <david-b@pacbell.net>]

From: David Brownell <dbrownell@users.sourceforge.net>

Make the U-Boot dm9000 driver read addresses from EEPROM just
like Linux does ... read six bytes, instead of reading twelve
bytes and then discarding every other one.

Using the right Ethernet address is a big win.

Signed-off-by: David Brownell <dbrownell@users.sourceforge.net>
---
 drivers/net/dm9000x.c |   12 ++++++------
 1 file changed, 6 insertions(+), 6 deletions(-)

--- a/drivers/net/dm9000x.c
+++ b/drivers/net/dm9000x.c
@@ -113,7 +113,7 @@ void eth_halt(void);
 static int dm9000_probe(void);
 static u16 phy_read(int);
 static void phy_write(int, u16);
-u16 read_srom_word(int);
+static void read_srom_word(int, u8 *);
 static u8 DM9000_ior(int);
 static void DM9000_iow(int reg, u8 value);
 
@@ -348,8 +348,8 @@ eth_init(bd_t * bd)
 	/* Set Node address */
 	if (!eth_getenv_enetaddr("ethaddr", enetaddr)) {
 #if !defined(CONFIG_AT91SAM9261EK)
-		for (i = 0; i < 6; i++)
-			enetaddr[i] = read_srom_word(i);
+		for (i = 0; i < 3; i++)
+			read_srom_word(i, enetaddr + 2 * i);
 		eth_setenv_enetaddr("ethaddr", enetaddr);
 #endif
 	}
@@ -541,14 +541,14 @@ eth_rx(void)
 /*
   Read a word data from SROM
 */
-u16
-read_srom_word(int offset)
+static void read_srom_word(int offset, u8 *to)
 {
 	DM9000_iow(DM9000_EPAR, offset);
 	DM9000_iow(DM9000_EPCR, 0x4);
 	udelay(8000);
 	DM9000_iow(DM9000_EPCR, 0x0);
-	return (DM9000_ior(DM9000_EPDRL) + (DM9000_ior(DM9000_EPDRH) << 8));
+	to[0] = DM9000_ior(DM9000_EPDRL);
+	to[1] = DM9000_ior(DM9000_EPDRH);
 }
 
 void