From mboxrd@z Thu Jan  1 00:00:00 1970
From: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
Date: Fri, 17 Apr 2009 21:32:32 +0200
Subject: [U-Boot] Allocating a frame buffer in memory
In-Reply-To: <22993711.post@talk.nabble.com>
References: <22993711.post@talk.nabble.com>
Message-ID: <20090417193232.GA5679@game.jcrosoft.org>
List-Id: <u-boot.lists.denx.de>
MIME-Version: 1.0
Content-Type: text/plain; charset="us-ascii"
Content-Transfer-Encoding: 7bit
To: u-boot@lists.denx.de

On 13:13 Fri 10 Apr     , Steven Zedeck wrote:
> 
> Hi,
> I am trying to allocate a frame buffer for my LCD code. I think I understand
> how to set up the LCC controller in the Atmel AT91SAM9. So thats not the
> issue, at least not yet. I need to understand how UBoot allocates a block of
> memory for the buffer.
> 
> My TFT/LCD is 320x240 and in 24 bit mode, so 3 bytes per pixel. So I think I
> need 320x240x3 total bytes. Correct?
> 
> In my lib_arm/board.c file, there is the following:
> #ifdef CONFIG_LCD
> 	/* board init may have inited fb_base */
> 	if (!gd->fb_base) {
> #		ifndef PAGE_SIZE
> #		  define PAGE_SIZE 4096
> #		endif
> 		/*
> 		 * reserve memory for LCD display (always full pages)
> 		 */
> 		/* bss_end is defined in the board-specific linker script */
> 		addr = (_bss_end + (PAGE_SIZE - 1)) & ~(PAGE_SIZE - 1);
> 		size = lcd_setmem (addr);
> 		gd->fb_base = addr;
> 	}
> #endif /* CONFIG_LCD */
> 
> Then in lcd.c, there is lcd_setmem which displays:
> Reserving 600k for LCD Framebuffer at: 0x23E91000
> 
> Even though I call lcd_setmem with an address of: 0x23F27000
> 
> Which is the address that I pass to the Atmel LCD controller DMA Address ?
> I have been using this: 0x23F27000
on at91sam9 to specify the frambuffer base address you will just need to fill
 gd->fb_base = AT91SAM9263_SRAM0_BASE;
 or something else as done with the PSRAM for the pm9263
 in your board init and specify your "vidinfo_t panel_info"
 that's all (maybe you will need to check the LCD pin out configuration)

Best Regards,
J.