[U-Boot] [PATCH] nand/mpc512x: Add MPC512x NAND support (NFC)

[Stefan Roese <sr@denx.de>]

On Monday 08 June 2009 20:08:21 Wolfgang Denk wrote:
> > > I do not see ADS5121 support in posted driver code. ADS5121 board
> > > controls NAND chip selects via external CPLD and do not use controller
> > > chip select signals. Linux driver has workaround for this special case.
> >
> > Yes, I know. I explicitly removed this code because of two reasons:
>
> Argh. That's a really stupid thing to do.

Did you actually see the code? Did you see the board specific code added to 
the "common" NFC driver code? This is not really something I like to see in 
common drivers. And such code usually get's a NAK from you as well.

> > a) My basic testing platform was the esd mecp5123 board.
> >
> > b) I did some quick tests on the MCP5121ADS with this code (without
> >    this ADS specific chip-select handling) and didn't see any error.
> >
> > So I suggest to add the code as is for now. Such board specific routines
> > can be added later on when really needed.
>
> Nope. If the original version of the code contained this support, it
> makes no sense to me to actively remove it now and add additional
> effort later to re-add it.

As stated above this ADS addition is not a "clean" one. So there is effort 
necessary to make it acceptable. And as I also stated the driver works without 
this code just fine and the ADS. At least my tests didn't show any problems.

Best regards,
Stefan

=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================