[U-Boot] Question regarding FPGA firmware load in u-boot

[Dieter Kiermaier <dk-arm-linux@gmx.de>]

Prafulla,


> > -----Original Message-----
> > From: u-boot-bounces at lists.denx.de
> > [mailto:u-boot-bounces at lists.denx.de] On Behalf Of Dieter Kiermaier
> > Sent: Monday, June 22, 2009 2:30 PM
> > To: Andr? Schwarz
> > Cc: u-boot at lists.denx.de
> > Subject: Re: [U-Boot] Question regarding FPGA firmware load in u-boot
> >
> > Andr?,
> >
> > > Dieter,
> > >
> > > On Mon, 2009-06-22 at 08:19 +0200, Dieter Kiermaier wrote:
> > > > Andr?,
> > > >
> > > > > Dieter,
> > > > >
> > > > > On Fri, 2009-06-19 at 17:46 +0200, Dieter Kiermaier wrote:
> > > > > > Hello List,
> > > > > >
> > > > > > I want to boot a (Lattice) FPGA from u-boot by using Slave
> > > > > > Serial configuration on a Marvell Kirkwood device.
> > > > >
> > > > > Should be no problem as long as you'll have access to GPIO.
> > > >
> > > > I'm working on it :)
> > > > But more likely I would have the SPI controller to do the
> > > > serializing of the bitstream. But maybe this would be the
> >
> > second step.
>
> Hi
> Pls see my patch, hopefully this is useful for you
> http://lists.denx.de/pipermail/u-boot/2009-June/053605.html

Thanks for pointing to it.
But as I tried to explain, the common SPI driver is useless for my board due 
to the kirkwood pin multiplexing. Thats why I asked for a TDM module based 
SPI driver in the past.
(Please see my comment on the openplug wiki from today morning for a more 
detailed explanation)

Dieter


> Regards..
> Prafulla . .