[U-Boot] [PATCH v3] ppc4xx: Add GDsys CompactCenter board support.

[Stefan Roese <sr@denx.de>]

On Monday 13 July 2009 16:28:33 Eibach, Dirk wrote:
> > > I narrowed it down to board_early_init_r() where
> >
> > remove_tlb() is done.
> >
> > Before or after the remove_tlb()?
>
> It is in remove_tlb().

OK.

> > > When I do a 'res halt' 'res run' sequence with the BDI the
> >
> > board comes
> >
> > > up fine.
> > >
> > > Any ideas?
> >
> > No, sorry. I haven't done much work on Canyonlands lately. Is
> > this problem new? When did it first appear on your system?
>
> u-boot-2009.01 works fine. After upgrading to current git I didn't
> notice the problem at once because it appears only after powercycling
> the board.

I suggest you halt (while (1) ;) you system right before the remove_tlb() call 
and check the TLB setup via the BDI. This should give you an idea what's wrong 
here.

Otherwise "git bisect" is your fried...

Thanks.

Best regards,
Stefan

=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================