From mboxrd@z Thu Jan  1 00:00:00 1970
From: Stefan Roese <sr@denx.de>
Date: Fri, 24 Jul 2009 10:45:27 +0200
Subject: [U-Boot] PPC440GX TLB setting problem.
In-Reply-To: <4CD35CD1F8085945B597F80EEC8942130348D993@exc01.bk.prodrive.nl>
References: <4CD35CD1F8085945B597F80EEC8942130348D991@exc01.bk.prodrive.nl>
	<200907240852.46998.sr@denx.de>
	<4CD35CD1F8085945B597F80EEC8942130348D993@exc01.bk.prodrive.nl>
Message-ID: <200907241045.27755.sr@denx.de>
List-Id: <u-boot.lists.denx.de>
MIME-Version: 1.0
Content-Type: text/plain; charset="us-ascii"
Content-Transfer-Encoding: 7bit
To: u-boot@lists.denx.de

Hi Wouter,

On Friday 24 July 2009 09:48:17 Wouter Eckhardt wrote:
> Yes, I've checked the VxWorks kernel code. The comments mention that if
> caching is enabled, the cache should be flushed before the call to MMU
> TLB initialization is done. However, the calling code never actually
> flushes the cache. So they're not even following their own advice. In
> the calling code, they just assume that caching is disabled.

OK.

> > > - Is U-Boot reconfiguring the TLBs after init.S has executed?
> >
> > Yes. But only one (IIRC). The first TLB for bootrom access. Caching
> > will be disabled before relocating to SDRAM.
> Hmmm. This should be a problem since I changed the TLB settings to have
> SDRAM at the first TLB. However, the SDRAM gets remapped in a different
> TLB as well. Where in the code can I find this? I tried looking for
> something like that, but couldn't find it. Perhaps that piece of code is
> actually replacing all TLBs, not just the bootrom access one.

Take a look at Sequoia. It has support for VxWorks booting. You need to switch 
the sequence of the TLB entries. init.S:

	/* vxWorks needs this as first entry for the Machine Check interrupt */
	tlbentry( 0x40000000, SZ_256M, 0, 0, AC_R|AC_W|AC_X|SA_G|SA_I )

And you need to set CONFIG_SYS_TLB_FOR_BOOT_FLASH in your board config header 
to the number of the boot TLB entry.

Let me know if this helps.

Best regards,
Stefan

=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================