[U-Boot] [PATCH] NAND: DaVinci: Adding 4 BIT ECC support

[Wolfgang Denk <wd@denx.de>]

Dear Scott Wood,

In message <4A8ACBD0.6060309@freescale.com> you wrote:
> Paulraj, Sandeep wrote:
> > And please correct me if I am wrong, but J-C can't actually pull these patches into his next branch correct?
> 
> Right, not yet.
> 
> > That is because it will require 2 of the NAND patches that I sent a week ago.
> > 
> > Thus you might have to accept the DM355 EVM config update patch as well which actually enables the NAND support.
> 
> I could do that with an ACK from JC if it does not depend on anything in 
> his tree -- or I could send Wolfgang a -next pull request and then JC 
> could sync with that.

Jean-Christophe has acked this one - see
http://thread.gmane.org/gmane.comp.boot-loaders.u-boot/65792/focus=66144

But I'm concerned about direct register accesses. We really should
insist on using proper accessor calls.

Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
Always leave room to add an explanation if it doesn't work out.