[U-Boot] ERROR: too many flash sectors

SlinceArm
2009-08-20T14:45:28Z

Hi , everyone .

My u-boot version is 2009-01 and i try porting u-boot on pxa270 development
board.
when i power on my board then minicom show these information

DRAM: 64 MB
ERROR: too many flash sectors
ERROR: too many flash sectors
Flash: 32 MB

then i can save setenv , but when i earse my flash ,it cause one error

Error: end address not on sector boundary

and here is my flinfo :

Bank # 1: CFI conformant FLASH (32 x 16) Size: 32 MB in 128 Sectors
Intel Extended command set, Manufacturer ID: 0x89, Device ID: 0x18
Erase timeout: 4096 ms, write timeout: 1 ms
Buffer write timeout: 2 ms, buffer size: 64 bytes

Sector Start Addresses:
00000000 RO 00040000 RO 00080000 RO 000C0000 RO 00100000
RO
etc...

And i dont know my network chip work or not . ( my chip is LAN91C113 )
when i ping some address , it show

ethid=0000...
LAN91C113:PHY auto-negotiate timed out

then my bootloader freeze ....

would someone can help me ? thanks.

--
View this message in context: http://www.nabble.com/-U-Boot--ERROR%3A-too-many-flash-sectors-tp25063511p25063511.html