From mboxrd@z Thu Jan 1 00:00:00 1970 From: Stefan Roese Date: Fri, 11 Sep 2009 15:21:10 +0200 Subject: [U-Boot] configure ppc440spe as pci adapter In-Reply-To: <25389144.post@talk.nabble.com> References: <25389144.post@talk.nabble.com> Message-ID: <200909111521.10401.sr@denx.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On Thursday 10 September 2009 21:01:57 dbrazeau wrote: > I'm trying to get my ppc440spe (Katmai) board to initialize in PCI adapter > mode. I was hoping that someone could give me some pointers on what > changes I need in the katmai config file, i.e. do I need to define > CONFIG_SYS_PCI_MASTER_INIT. Also I noticed that some ppc4xx have > PCI_HOST_ADAPTER defined, but this is not defined in the Katmai config > file. Should I define it and define CONFIG_PCI_HOST to it? Any comments > are greatly appreciated. Thanks. I don't know of any 440SPe based board used in PCI adapter mode. But you could probably check the esd PMC440 board. This is a PPC440EPx based PMC module which can be configured/built either as PCI host or as PCI adapter. Cheers, Stefan -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-0 Fax: (+49)-8142-66989-80 Email: office at denx.de