[U-Boot] Please pull u-boot-mpc85xx

Wolfgang Denk
2012-04-30T14:51:01Z

Dear Andy Fleming,

In message <1335330687-19925-1-git-send-email-afleming@freescale.com> you wrote:
>
> The following changes since commit 61ddce07f8b96c5df7d00466b4da9edaecb0eff1:
>
> sandbox: Use the new run_command() (2012-04-23 22:53:54 +0200)
>
> are available in the git repository at:
> git://www.denx.de/git/u-boot-mpc85xx.git master
>
> Chunhe Lan (1):
> powerpc/p1023rds: Disable nor flash node and enable nand flash node
>
> Jerry Huang (1):
> PowerPC: correct the SATA for p1/p2 rdb-pc platform
>
> Liu Gang (8):
> powerpc/srio: Rewrite the struct ccsr_rio
> powerpc/corenet_ds: Correct the compilation errors about ENV
> powerpc/corenet_ds: Document for the boot from SRIO
> powerpc/corenet_ds: Master module for boot from SRIO
> powerpc/corenet_ds: Slave module for boot from SRIO
> powerpc/corenet_ds: Slave uploads ucode when boot from SRIO
> powerpc/corenet_ds: Slave reads ENV from master when boot from SRIO
> powerpc/corenet_ds: Slave core in holdoff when boot from SRIO
>
> Prabhakar Kushwaha (4):
> powerpc/85xx:Avoid hardcoded vector address for IVORs
> powerpc/85xx:Fix IVORs addr after vector table relocation
> powerpc/85xx:Avoid vector table compilation for nand_spl
> powerpc/85xx:Fix lds for nand boot debug info
>
> Shaohui Xie (2):
> powerpc/p2041rdb: add NAND and NAND boot support
> powerpc/p2041rdb: add env in NAND support
>
> Timur Tabi (3):
> cmd_bdinfo: display the address map size (32-bit vs. 36-bit)
> powerpc/85xx: don't display address map size (32-bit vs. 36-bit) during boot
> powerpc/85xx: don't touch MAS7 on e500v1 when relocating CCSR
>
> York Sun (1):
> powerpc/mpc8xxx: Fix CONFIG_DDR_RAW_TIMING for two boards
>
> README | 24 ++
> arch/powerpc/cpu/mpc85xx/cpu_init.c | 9 +-
> arch/powerpc/cpu/mpc85xx/start.S | 112 ++++++---
> arch/powerpc/cpu/mpc85xx/u-boot-nand.lds | 4 +-
> arch/powerpc/cpu/mpc8xxx/srio.c | 210 +++++++++++++++
> arch/powerpc/include/asm/config_mpc85xx.h | 46 ++++
> arch/powerpc/include/asm/fsl_srio.h | 64 +++++
> arch/powerpc/include/asm/immap_85xx.h | 387 ++++++++++++++++-----------
> board/freescale/common/p_corenet/law.c | 13 +
> board/freescale/common/p_corenet/tlb.c | 19 ++
> board/freescale/corenet_ds/corenet_ds.c | 4 -
> board/freescale/mpc8536ds/mpc8536ds.c | 7 +-
> board/freescale/mpc8572ds/mpc8572ds.c | 6 +-
> board/freescale/mpc8641hpcn/mpc8641hpcn.c | 3 -
> board/freescale/p1010rdb/ddr.c | 6 +-
> board/freescale/p1010rdb/p1010rdb.c | 6 +-
> board/freescale/p1022ds/p1022ds.c | 8 +-
> board/freescale/p1023rds/p1023rds.c | 6 +
> board/freescale/p1_p2_rdb/p1_p2_rdb.c | 4 +-
> board/freescale/p1_p2_rdb_pc/ddr.c | 4 +-
> board/freescale/p1_p2_rdb_pc/p1_p2_rdb_pc.c | 8 +-
> board/freescale/p2020ds/p2020ds.c | 8 +-
> board/freescale/p2041rdb/p2041rdb.c | 4 -
> board/freescale/p3060qds/p3060qds.c | 3 -
> boards.cfg | 7 +
> common/Makefile | 1 +
> common/cmd_bdinfo.c | 8 +
> common/cmd_nvedit.c | 3 +-
> common/env_remote.c | 79 ++++++
> doc/README.srio-boot-corenet | 103 +++++++
> drivers/net/fm/fm.c | 2 +
> include/configs/P1010RDB.h | 2 +-
> include/configs/P2041RDB.h | 59 ++++-
> include/configs/corenet_ds.h | 75 +++++
> include/configs/p1_p2_rdb_pc.h | 4 +-
> 35 files changed, 1047 insertions(+), 261 deletions(-)
> create mode 100644 arch/powerpc/include/asm/fsl_srio.h
> create mode 100644 common/env_remote.c
> create mode 100644 doc/README.srio-boot-corenet

Applied, thanks.

Best regards,

Wolfgang Denk

--
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
Premature optimization is the root of all evil. -- D.E. Knuth