[U-Boot] FPGA relocation/C environment

[Wolfgang Wegner <wolfgang@leila.ping.de>]

Dear Joakim Tjernlund,

On Thu, Oct 29, 2009 at 02:08:05PM +0100, Joakim Tjernlund wrote:
> 
> Just to avoid any misunderstandings, the GOT does not hold offsets, it holds
> absolute addresses. These addresses gets adjusted with an offset when you
> relocate.

thank you, I already understood this.

As far as I can see there is already some GOT handling in cpu/mcf532x/start.S
and the flags (-fPIC) in cpu/mcf532x/config.mk (and other coldfire ports, but
MCF532x/MCF537x is what I am currently working on for testing), but somehow
it does not work.
However, it takes some time for me to understand the assembler code, 
especially the powerpc counterpart I am using as a reference.

There is a __got_start and __got_end in my u-boot.map, so I would think
the linker does behave correctly - but I did not yet check if all the
symbols (better: symbols' addresses) expected to be there are really
present:

.reloc          0x00024600     0x1990
                0x00024600                __got_start = .
 *(.got)
 .got           0x00024600     0x1990 cpu/mcf532x/cpu_init.o
                0x00025f90                __got_end = .
                0x00025f90                _GOT2_TABLE_ = .
 *(.got2)
                0x00025f90                _FIXUP_TABLE_ = .
 *(.fixup)
                0x00000000                __got2_entries = ((_FIXUP_TABLE_ - _GOT2_TABLE_) >> 0x2)
                0x00000000                __fixup_entries = ((. - _FIXUP_TABLE_) >> 0x2)

(flash resides at 0x0, SDRAM at 0x4000000 and CONFIG_SYS_MONITOR_BASE is
0x40020000)

Regards,
Wolfgang