[U-Boot] SMDK2410 board

[U-Boot] SMDK2410 board

[David Kaplan]

I'm trying to get u-boot running on a smdk2410-based board.
I'm using openocd and jtag and am trying to load u-boot into ram as follows:

load_image u-boot.bin 0x33f80000

Which *seems* to work:
103668 bytes written at address 0x33f80000
downloaded 103668 byte in 0.500045s

I then try to run it by using resume 0x33f80000 but it doesn't seem that
u-boot is executing.
What am I doing wrong?

[U-Boot] SMDK2410 board

[Wolfgang Denk]

Dear David Kaplan,

In message <62564a490911010039xb4c7768mb51016cdd42c8e81@mail.gmail.com> you wrote:
>
> I'm using openocd and jtag and am trying to load u-boot into ram as follows:
...
> I then try to run it by using resume 0x33f80000 but it doesn't seem that
> u-boot is executing.
> What am I doing wrong?

Maybe you failed tor ead the FAQ:
http://www.denx.de/wiki/view/DULG/CanUBootBeConfiguredSuchThatItCanBeStartedInRAM

Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
That said, there may be good reasons for what you did beyond obsequi-
ous sycophantic parody. Perhaps you might be so kind as to elucidate.
         -- Tom Christiansen in <5ldjbm$jtk$1@csnews.cs.colorado.edu>