[U-Boot] [PATCH] NAND: DaVinci: Update 4 bit ECC correction

[Scott Wood <scottwood@freescale.com>]

On Tue, Dec 01, 2009 at 05:24:59PM -0500, s-paulraj at ti.com wrote:
> From: Sandeep Paulraj <s-paulraj@ti.com>
> 
> There was a bug in the 4 bit ECC calculation routine
> in the DaVinci NAND driver. This becomes prominent
> when we use 4K page size NAND devices.
> This is a fix for the issue.
> 
> Signed-off-by: Sandeep Paulraj <s-paulraj@ti.com>
> ---
>  drivers/mtd/nand/davinci_nand.c |   11 +++++++++++
>  1 files changed, 11 insertions(+), 0 deletions(-)
> 
> diff --git a/drivers/mtd/nand/davinci_nand.c b/drivers/mtd/nand/davinci_nand.c
> index 41a9568..68a0e15 100644
> --- a/drivers/mtd/nand/davinci_nand.c
> +++ b/drivers/mtd/nand/davinci_nand.c
> @@ -388,6 +388,17 @@ static int nand_davinci_4bit_correct_data(struct mtd_info *mtd, uint8_t *dat,
>  	emif_regs->NANDFCR |= 1 << 13;
>  
>  	/*
> +	 * ECC_STATE in NANDFSR register reads 0x3 (Error correction complete)
> +	 * immediately after setting the 4BITECC_ADD_CALC_START bit. So if we
> +	 * begin trying to poll for the state, we may fall right out of your
> +	 * loop

"your" loop?

>  without any of the correction calculations having taken place.
> +	 * So wait till ECC_STATE reads less than 4.
> +	 */
> +	do {
> +		val = ((emif_regs->NANDFSR >> 8) & 0xf);
> +	} while (val < 4);

Comment says wait until less than 4, code says wait until@least 4.  Could
symbolic constants be used to describe the states instead of magic numbers
like 4 and 0xc00?

Is it possible that there could be a race, whereby the hardware finishes
before you read NANDFSR for the first time, and thus you never see it be
greater than 3?

-Scott