From mboxrd@z Thu Jan 1 00:00:00 1970 From: Stefan Roese Date: Wed, 30 Dec 2009 12:51:29 +0100 Subject: [U-Boot] Board is not booting after flashing U-boot and hard reset In-Reply-To: References: <200912300621.39211.sr@denx.de> Message-ID: <200912301251.29312.sr@denx.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Hi Prakash, On Wednesday 30 December 2009 12:31:52 prakash bedge wrote: > I am using PPC440GX. > I did not understood what mean by EEPROM configuration. Do you want to say > that board is using data from EEPROM? I'm talking about the bootstrap controller of the PPC. I suggest you take a look at chapter "9. IIC Bootstrap Controller" for more information about this. > I believe I am using fix configuration as I am not calling any I2C call in > bootloader code. You don't need to call it. The PPC is reading these I2C bootstrap values *before* starting the first lines of code from flash (if configured to use the I2C bootstrapping). So how are the strapping pins (UART0_DCD, UART0_DSR) configured in your custom board? Cheers, Stefan -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-0 Fax: (+49)-8142-66989-80 Email: office at denx.de