From mboxrd@z Thu Jan  1 00:00:00 1970
From: Stefan Roese <sr@denx.de>
Date: Mon, 4 Jan 2010 06:45:04 +0100
Subject: [U-Boot] Sequoia EHCI
In-Reply-To: <314701ca8bfa$d0a99520$71fcbf60$@com>
References: <314701ca8bfa$d0a99520$71fcbf60$@com>
Message-ID: <201001040645.04426.sr@denx.de>
List-Id: <u-boot.lists.denx.de>
MIME-Version: 1.0
Content-Type: text/plain; charset="us-ascii"
Content-Transfer-Encoding: 7bit
To: u-boot@lists.denx.de

Hi Chris,

On Saturday 02 January 2010 23:25:50 Chris Zhang wrote:
> I was trying to get EHCI running on sequoia board (ppc440epx).

EHCI is currently not supported in U-Boot for PPC4xx.
 
> I'm getting the following message when issuing "usb start" .
> 
> 
> 
> Cannot enable port 1 after 5 retries, disabling port.
> 
> Maybe the USB cable is bad?
> 
> Cannot reset port 1!?
> 
> 1 USB Device(s) found
> 
>                 Scanning bus for storage devices. 0 Storage Device(s)
> found
> 
> =>
> 
> 
> 
> EHCI works fine under operating system (a customized NetBSD). This is the
> configuration I'm using,
> 
> .
> 
> #define CONFIG_USB_EHCI
> 
> #define CONFIG_USB_EHCI_PPC4XX     /* added ehci-ppc4xx.c similar as
> ehci-ixp4xx.c */

I don't know of an ehci-ppc4xx.c file. Did you create it yourself?
 
Cheers,
Stefan

--
DENX Software Engineering GmbH,      MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich,  Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-0 Fax: (+49)-8142-66989-80 Email: office at denx.de