* [U-Boot] uboot.bin for smdkc100_config fails to boot from NAND
@ 2010-01-13 9:51 Naveen Krishna Ch
2010-01-13 18:19 ` Scott Wood
0 siblings, 1 reply; 2+ messages in thread
From: Naveen Krishna Ch @ 2010-01-13 9:51 UTC (permalink / raw)
To: u-boot
Hi All,
I have a SMDKC100 boards with Single chip NAND
Built the mainline uboot for
Das U-Boot# smdkc100_config; make
i use a In-Circuit Debugger to flash the uboot.bin
to the NAND.
I checked the dip switches & Jumpers are proper.
The In-Circuit Debugger shows "Emulation running"
But, nothing comes up on the UART0
What could be the problem, Any pointers..
--
Shine bright,
(: Naveen Krishna Ch :)
^ permalink raw reply [flat|nested] 2+ messages in thread
* [U-Boot] uboot.bin for smdkc100_config fails to boot from NAND
2010-01-13 9:51 [U-Boot] uboot.bin for smdkc100_config fails to boot from NAND Naveen Krishna Ch
@ 2010-01-13 18:19 ` Scott Wood
0 siblings, 0 replies; 2+ messages in thread
From: Scott Wood @ 2010-01-13 18:19 UTC (permalink / raw)
To: u-boot
On Wed, Jan 13, 2010 at 03:21:50PM +0530, Naveen Krishna Ch wrote:
> Hi All,
>
> I have a SMDKC100 boards with Single chip NAND
>
> Built the mainline uboot for
>
> Das U-Boot# smdkc100_config; make
>
> i use a In-Circuit Debugger to flash the uboot.bin
> to the NAND.
>
> I checked the dip switches & Jumpers are proper.
>
> The In-Circuit Debugger shows "Emulation running"
> But, nothing comes up on the UART0
>
> What could be the problem, Any pointers..
Does this chip/board have special hardware/ROM to load a full u-boot image
out of NAND into somewhere it can execute?
If not, you'll need nand_spl support for this board.
-Scott
^ permalink raw reply [flat|nested] 2+ messages in thread
end of thread, other threads:[~2010-01-13 18:19 UTC | newest]
Thread overview: 2+ messages (download: mbox.gz follow: Atom feed
-- links below jump to the message on this page --
2010-01-13 9:51 [U-Boot] uboot.bin for smdkc100_config fails to boot from NAND Naveen Krishna Ch
2010-01-13 18:19 ` Scott Wood
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox