From mboxrd@z Thu Jan 1 00:00:00 1970 From: Albin Tonnerre Date: Mon, 15 Mar 2010 21:10:21 +0100 Subject: [U-Boot] at91sam9g45ekes SDHC/MMC In-Reply-To: References: Message-ID: <20100315201021.GC14032@pc-ran3241> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On Mon, 15 Mar 2010 15:51 -0400, Henry S?cart wrote : > Hi, Hi Henry, > I've been trying to get an SD card working with an at91sam9g45ek-es board. I > read a couple of threads in the archive and ended up doing this: > > I applied these patches: > > http://lists.denx.de/pipermail/u-boot/2009-August/059595.html > http://lists.denx.de/pipermail/u-boot/2009-September/060053.html > http://lists.denx.de/pipermail/u-boot/2009-September/060243.html > > Added these #define's to include/configs/at91sam9m10g45ek.h: > > #define CONFIG_CMD_EXT2 1 > #define CONFIG_CMD_FAT 1 > #define CONFIG_CMD_MMC 1 > #define CONFIG_MMC 1 > #define CONFIG_ATMEL_MCI 1 > > Finally, I added this to the board init function: > > #ifdef CONFIG_ATMEL_MCI > at91_mci0_hw_init(0, 4); > #endif > > When I try it out this is what I get: > U-Boot> mmc init 0 > mmc: clock 150000 too low; setting CLKDIV to 255 > mmc: command 1 failed (status: 0x0c100025) > No MMC card found > > Am I doing something wrong? Any help is appreciated, Maybe you're not. The at91sam9m10g45 has 2 MMC ports, and the atmel_mci driver only uses one, defined using MMCI_BASE. Now if you look at the end of the third patch: diff --git a/include/asm-arm/arch-at91/memory-map.h b/include/asm-arm/arch-at91/memory-map.h index f605f37..de0aba7 100644 --- a/include/asm-arm/arch-at91/memory-map.h +++ b/include/asm-arm/arch-at91/memory-map.h @@ -32,4 +32,10 @@ #define USART3_BASE (AT91_BASE_SYS + AT91_DBGU) #define SPI0_BASE AT91_BASE_SPI +#ifndef CONFIG_AT91_MCI1 +#define MMCI_BASE AT91_BASE_MCI0 +#else +#define MMCI_BASE AT91_BASE_MCI1 +#endif + So maybe the issue is that it's trying to read on the wrong port. Could you try to add #define CONFIG_AT91_MCI1 in your board config, recompile and see if that works better? Thanks, -- Albin Tonnerre, Free Electrons Kernel, drivers and embedded Linux development, consulting, training and support. http://free-electrons.com