[U-Boot] bf537-stamp board compilation problem

[Wolfgang Denk <wd@denx.de>]

Dear Mike Frysinger,

In message <201004231533.58136.vapier@gentoo.org> you wrote:
>
> it.  i could just as easily say "i'd rather the code didnt assume powerpc 
> everywhere", but it isnt like that gets us from point a to point b.

I would have preferred an architecture neutral implementation as well,
but you know how it works: you start with just one specific processor
in mind, then another CPU of the same architecture gets added, and
when you try to add support for another architecture some rework and
cleanup is needed.  Same story here: first came MPC823E, then PPC440EX.
Both happened to be PPC...

Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
"The more data I punch in this card,  the lighter it becomes, and the
lower the mailing cost."
                     - Stan Kelly-Bootle, "The Devil's DP Dictionary"