From mboxrd@z Thu Jan 1 00:00:00 1970 From: Wolfgang Denk Date: Thu, 24 Jun 2010 11:14:43 +0200 Subject: [U-Boot] [PATCH 0/6] Update kirkwood egiga to allow dynamic phy addrs In-Reply-To: <1277370025-17281-1-git-send-email-tor@excito.com> References: <1277370025-17281-1-git-send-email-tor@excito.com> Message-ID: <20100624091443.1905B1524EE@gemini.denx.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Dear Tor Krill, In message <1277370025-17281-1-git-send-email-tor@excito.com> you wrote: > Today the kirkwood egiga driver assumes that phy addresses are > consecutive from a base address. > > Our new board design using this cpu unfortunately has a non contiguous > addressing of its phys and thus doesn't work with the current > implementation. > > This patchset updates the implementation to use an array of > phy addresses as configuration. > > Tor Krill (6): > Allow PHY addresses on kirkwood egiga to be non continuous. > Convert Suen3 board to use array of phy addrs > Convert Sheevaplug board to use array of phy addrs > Convert OpenRD board to use array of phy addrs > Convert Guruplug board to use array of phy addrs > Convert rd6281a board to use array of phy addrs Looking at what you are doing, things get even worse. This is an atomic change. This must be submitted as a single patch, not split into separate patches. Please read the documentatin and stick to the rules! NAK!! Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de Successful and fortunate crime is called virtue. - Seneca