From mboxrd@z Thu Jan  1 00:00:00 1970
From: Stefan Roese <sr@denx.de>
Date: Fri, 23 Jul 2010 10:16:28 +0200
Subject: [U-Boot] [PATCH] ppc4xx: T3CORP fixes and updates
In-Reply-To: <1279542262-27115-1-git-send-email-sr@denx.de>
References: <1279542262-27115-1-git-send-email-sr@denx.de>
Message-ID: <201007231016.28095.sr@denx.de>
List-Id: <u-boot.lists.denx.de>
MIME-Version: 1.0
Content-Type: text/plain; charset="us-ascii"
Content-Transfer-Encoding: 7bit
To: u-boot@lists.denx.de

On Monday 19 July 2010 14:24:22 Stefan Roese wrote:
> This patch fixes some problems for the T3CORP board. Here the list
> of the changes:
> 
> - Add 600-67 and 677 CPU frequency setting to chip_config
>   command
> - Define CONFIG_DDR_RFDC_FIXED on t3corp:
>   While using the "normal" auto calibration code, sometimes values for
>   RFDC were picked (>= T3) that resulted in a non-working U-Boot (hang
>   upon relocation, while running from SDRAM). With this optimized RFDC
>   value we can force this register and use the auto-calibration code to
>   setup the remaining calibration registers.
> - Increase sizes of FPGA chips selects
> - EBC timing updated OEN=3 for 66 MHz EBC speed
> - Change ext. IRQ2 setup to level-low active
> - Enable CONFIG_SYS_CFI_FLASH_STATUS_POLL

Applied to u-boot-ppc4xx/master. Thanks.

Cheers,
Stefan

--
DENX Software Engineering GmbH,      MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich,  Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-0 Fax: (+49)-8142-66989-80 Email: office at denx.de