[U-Boot] [PATCH] Use common function to set GPIOs for MX3 and MX5

[David Jander <david.jander@protonic.nl>]

On Friday 20 August 2010 12:20:25 pm Stefano Babic wrote:
> David Jander wrote:
> > Great. I'll wait.
> > In the meantime I have just done this to get it working:
> >
> > #ifdef CONFIG_MX31
> > void spi_cs_activate(struct spi_slave *slave)
> > {
> > 	struct mxc_spi_slave *mxcs = to_mxc_spi_slave(slave);
> > 	if (mxcs->gpio > 0)
> > 		mxc_gpio_set(mxcs->gpio, mxcs->ctrl_reg & MXC_CSPICTRL_SSPOL);
> > }
> 
> Ok, but one goal I have is to get rid of nasty #ifdef CONFIG_MX*. I
> introduce general gpio functions to make code more common, and I do not
> want to fall back adding processor switches.

Absolutely right. I just posted it as reference for your patch eventually, not 
because I thought it was good that way.

> > Seems to work, but never mind...
> 
> Ok, I will resend my patch, I hope you can give a chance a test it on
> your target.

Will do.
Btw, do you have any idea why spi_xchg_single() hangs while transmitting the 
second word without claiming the bus again?

Also, I don't know if you already fixed mxc_spi.c, to use the correct byte-
ordering when sending u8 buffers. I have a fix, but it is not yet ready.
I essentially renamed spi_xfer() to spi_xfer_fsl(), to be used in the (broken) 
pmic driver, and wrote a new spi_xfer() function which works correcly for u8 
buffers.

Best regards,

-- 
David Jander
Protonic Holland.