[U-Boot] [PATCH 1/4] OneNAND: Move largepage_memorybased

[Marek Vasut <marek.vasut@gmail.com>]

Dne So 2. ??jna 2010 19:33:56 Marek Vasut napsal(a):
> This moves "struct nand_bbt_descr largepage_memorybased" into
> "onenand_default_bbt" as that's the only place where this is used.
> 
> This also removes an entry from .data section. (For me, this section
> disappears after relocation).

Scott, can you please check this and the other three patches? Thanks
> 
> Signed-off-by: Marek Vasut <marek.vasut@gmail.com>
> ---
>  drivers/mtd/onenand/onenand_bbt.c |   25 ++++++++++++-------------
>  1 files changed, 12 insertions(+), 13 deletions(-)
> 
> diff --git a/drivers/mtd/onenand/onenand_bbt.c
> b/drivers/mtd/onenand/onenand_bbt.c index 1354877..c5d3905 100644
> --- a/drivers/mtd/onenand/onenand_bbt.c
> +++ b/drivers/mtd/onenand/onenand_bbt.c
> @@ -227,19 +227,6 @@ int onenand_scan_bbt(struct mtd_info *mtd, struct
> nand_bbt_descr *bd) return ret;
>  }
> 
> -/*
> - * Define some generic bad / good block scan pattern which are used
> - * while scanning a device for factory marked good / bad blocks.
> - */
> -static uint8_t scan_ff_pattern[] = { 0xff, 0xff };
> -
> -static struct nand_bbt_descr largepage_memorybased = {
> -	.options = 0,
> -	.offs = 0,
> -	.len = 2,
> -	.pattern = scan_ff_pattern,
> -};
> -
>  /**
>   * onenand_default_bbt - [OneNAND Interface] Select a default bad block
> table for the device * @param mtd		MTD device structure
> @@ -252,6 +239,18 @@ int onenand_default_bbt(struct mtd_info *mtd)
>  	struct onenand_chip *this = mtd->priv;
>  	struct bbm_info *bbm;
> 
> +	/*
> +	 * Define some generic bad / good block scan pattern which are used
> +	 * while scanning a device for factory marked good / bad blocks.
> +	 */
> +	uint8_t scan_ff_pattern[] = { 0xff, 0xff };
> +	struct nand_bbt_descr largepage_memorybased = {
> +		.options = 0,
> +		.offs = 0,
> +		.len = 2,
> +		.pattern = scan_ff_pattern,
> +	};
> +
>  	this->bbm = malloc(sizeof(struct bbm_info));
>  	if (!this->bbm)
>  		return -ENOMEM;