[U-Boot] [PATCH] FSL_ESDHC: Make the base address configurable at runtime

[Wolfgang Denk <wd@denx.de>]

Dear Marek Vasut,

In message <201011141735.30504.marek.vasut@gmail.com> you wrote:
> On Sunday 14 November 2010 17:01:02 Marek Vasut wrote:
> > This allows -after reimplementation of board_mmc_init() function- to set up
> > the base address of the eSDHC controller at runtime. This is useful on
> > iMX515 board I have, where there are two controllers and on different
> > revisions of the board, only one of them is used. The board revision can
> > be detected on runtime.
> 
> Just discussed this with Stefano, I guess this one will be a no-go, nevermind.

Does that mean we shall wait for a resubmit?


Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
The reasonable man adapts himself to the world; the unreasonable  one
persists  in  trying  to  adapt  the  world to himself. Therefore all
progress depends on the unreasonable man."      - George Bernard Shaw