[U-Boot] [PATCH] powerpc/85xx: Relocate env_addr if we CONFIG_SYS_RAMBOOT

[Wolfgang Denk <wd@denx.de>]

Dear Kumar Gala,

In message <1290008461-21171-1-git-send-email-galak@kernel.crashing.org> you wrote:
> We use CONFIG_SYS_RAMBOOT for when boot out of NAND, SPI, SDHC/MMC
> and utilize a L2 or L3 cache in SRAM mode.  In this case we will
> end up changing the cache from SRAM mode back to cache before we
> relocate the environment properly in env_relocate().
> 
> So we need to manual relocate the env pointer out of SRAM into DDR.
> 
> Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
> ---
>  arch/powerpc/lib/board.c |   12 ++++++++++++
>  1 files changed, 12 insertions(+), 0 deletions(-)
> 
> diff --git a/arch/powerpc/lib/board.c b/arch/powerpc/lib/board.c
> index 2e0749d..5ce9caa 100644
> --- a/arch/powerpc/lib/board.c
> +++ b/arch/powerpc/lib/board.c
> @@ -645,6 +645,18 @@ void board_init_r (gd_t *id, ulong dest_addr)
>  	gd->cpu += dest_addr - CONFIG_SYS_MONITOR_BASE;
>  #endif
>  
> +#if defined(CONFIG_MPC85xx) && defined(CONFIG_SYS_RAMBOOT)
> +	/*
> +	 * We use CONFIG_SYS_RAMBOOT for when boot out of NAND, SPI, SDHC/MMC

I think this is a bad misuse of the CONFIG_SYS_RAMBOOT variable here.
Assume I have a 85xx system where U-Boot gets loaded by some means
into DDR.  Of course I will have CONFIG_MPC85xx and CONFIG_SYS_RAMBOOT
set, but I do not want in any way that this special mechanism kicks
in.

Please use a (new) specific feature-define for this.

Please also make sure to check other parts of the code if they use
this obviously unsuitable construct!


Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
We fight only when there is no other choice. We prefer  the  ways  of
peaceful contact.
	-- Kirk, "Spectre of the Gun", stardate 4385.3