[U-Boot] [PATCH] xilinx_ppc_boards: Change address of RESET_VECTOR

[Wolfgang Denk <wd@denx.de>]

Dear Ricardo Ribalda Delgado,

In message <1294823682-12502-1-git-send-email-ricardo.ribalda@gmail.com> you wrote:
> Old address of RESET_VECTOR were overwritten by the bss sector, making
> impossible its run from xmd.
> 
> Signed-off-by: Ricardo Ribalda Delgado <ricardo.ribalda@gmail.com>

I would like to minimize the configuration information present in
boards.cfg; the current state resulted just from the attempt to
minimize changes when converting to from Makefile to boards.cfg, but
that should not be the final state.

When you touch all of this anyway (and re-test it, obviously), can you
then please take the chance and move all tis stuff from boards.cfg
into your respective board config files, where it aktucally belongs?

Thanks.

Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
The best things in life are for a fee.