[U-Boot] [PATCH 2/5] pci: option for configurable delay between pci reset and pci bus scan

[Anatolij Gustschin <agustschin@t-online.de>]

Hi Detlev,

On Fri, 27 May 2011 17:26:24 +0200
Detlev Zundel <dzu@denx.de> wrote:
...
> > PCI cards might need some time after reset to respond.
> > On some boards (mpc5200 or mpc8260 based) the PCI bus reset is
> > deasserted at pci_board_init() time, so we can not use available
> > "pcidelay" option for waiting before pci bus scan here. Add an option
> > to delay bus scan by setting "pci_scan_delay" environment variable.
> 
> Hm, I'm not sure I understand the situation, so please correct me.  We
> have a "pcidelay" variable, which is used to wait before
> pci_board_init() (I'm not counting the semantically different usage in
> the esd boards).  This does not fit your need, so you define
> pci_scan_delay which is used _after_ pci_init_board(), correct?

yes, this is correct.

> If this is correct, then why don't you keep your new delay also in the
> pci_init() function so that the delays are easily visible on code
> inspection?  But wait, if this is only needed for this very board, then
> why don't we put the delay into digsys pci_init_board?  Actually I think
> this is the best way, as on this board we always need the delay as PCI
> is not hotplug.

The reason for not keeping new delay in pci_init() is:
pci_init_board() starts scanning the bus (calls pci_hose_scan()), so
when pci_init_board() returns, it is too late, the scanning is
already completed.

digsy's pci_init_board() just calls pci_mpc5xxx_init(), when the latter
returns, the scanning is completed, too. PCI reset is de-asserted in
pci_mpc5xxx_init(), so I thought about putting the delay there, but
similar situation is also on mpc8260 based boards, pci_mpc8250_init()
de-asserts PCI reset and waits on some boards (on MPC8266ADS 1 sec).
So the problem is not only digsy specific. The needed time after reset
before config cycles could be up to 1 sec, depending on the card. The
pci spec 2.2 allows this.

I think that it would be good to run arch specific pci init not from
the pci_board_init(), but from pci_init(). Then we can add delay
code in the board specific way. This would reduce the code duplication,
too. Currently we have the same pci_init_board() for many 5200 boards,
except for mvbc_p and mvsmr boards.

> Apart from that, having two variables "pcidelay" and "pci_scan_delay" we
> would need good documentation to explain their usage - the names do not
> help (me) much ;)

Sure. If there is an agreement to solve the problem as proposed in
the patch, I'll add the documentation in the next patch version.
Maybe someone have a better idea, lets wait a bit for other comments.
Actually I don't like the name of the variable, it is somehow
misleading. Any better name?

Thanks,
Anatolij