[U-Boot] [PATCH 20/20] M28EVK: Enable USB HOST support

[Marek Vasut <marek.vasut@gmail.com>]

> Marek Vasut wrote:
> >> Marek Vasut wrote:
> >>>> Marek Vasut wrote:
> >>>>>> Hi Marek,
> >>>>>> 
> >>>>>> u-boot-v2011.09 doesn't support for imx28. I need complete support
> >>>>>> patch for mx28. where can i get those patches?
> >>>>>> 
> >>>>>> for which version of u-boot this patches supports..?
> >>>>>> 
> >>>>>> 
> >>>>>> Regards,
> >>>>>> Manoj
> >>>>> 
> >>>>> http://git.denx.de/?p=u-boot/u-boot-imx.git;a=summary
> >>>>> 
> >>>>> M
> >>>> 
> >>>> Thanks Marek,
> >>>> Patches applied..
> >>>> on usb start command i'm getting "scanning bus for devices... New
> >>>> Device 0" then its freezes after  getting the debug message
> >>>> "enabling power on all ports
> >>>> usb_control_msg: request: 0x3, requesttype: 0x23, value 0x8 index 0x1
> >>>> length 0x0"
> >>>> can u help me on this further?
> >>>> 
> >>>> Regards,
> >>>> Manoj
> >>> 
> >>> There is a mail with subject "[U-Boot] [PATCH] GCC4.6: Fix common/usb.c
> >>> on xscale" in uboot ML ... apply the patch and retry. What GCC do you
> >>> use?
> >>> 
> >>> M
> >> 
> >> Hello Marek,
> >> 
> >> I'm using
> >> u-boot version : u-boot-imx
> >> 
> >> gcc version:4.3.3
> >> 
> >> When i try to add this Patch "[U-Boot] [PATCH] GCC4.6: Fix common/usb.c
> >> on xscale"
> >> I'm getting:
> >> patching file usb.c
> >> Hunk #1 FAILED at 263.
> >> Hunk #2 FAILED at 313.
> >> 2 out of 2 hunks FAILED -- saving rejects to file usb.c.rej
> >> 
> >> then i made some changes for common/usb.c as per the patch,even it gets
> >> freezes after printing the debug msg.
> >> "enabling power on all ports
> >> usb_control_msg: request: 0x3, requesttype: 0x23, value 0x8 index 0x1
> >> length 0x0"
> >> 
> >> Regards,
> >> Manoj
> > 
> > Are you using top-of-the-tree u-boot-imx/master? You shouldn't need to
> > apply any patches. That'd explain why you're getting errors applying the
> > last USB patch I suggested.
> > 
> > Also, please try ELDK5.0 toolchain.
> > 
> > M
> 
> Marek,
> 
> ya i'm using master code and now its working fine..

Is it because of "[U-Boot] [PATCH] GCC4.6: Fix common/usb.c on xscale" or 
ELDK5.0 or Using u-boot/master ? What did you change?

Anyway, it's good to hear!!

M