[U-Boot] [PATCH] M28: Document that units has to be set to sectors on SD bootcard

[Marek Vasut <marek.vasut@gmail.com>]

> Dear Marek Vasut,
> 
> In message <1322153845-19369-1-git-send-email-marek.vasut@gmail.com> you 
wrote:
> > Signed-off-by: Marek Vasut <marek.vasut@gmail.com>
> > Cc: Stefano Babic <sbabic@denx.de>
> > Cc: Wolfgang Denk <wd@denx.de>
> > ---
> > 
> >  doc/README.m28 |    6 ++++++
> >  1 files changed, 6 insertions(+), 0 deletions(-)
> > 
> > diff --git a/doc/README.m28 b/doc/README.m28
> > index b749ce0..242230b 100644
> > --- a/doc/README.m28
> > +++ b/doc/README.m28
> > 
> > @@ -116,6 +116,12 @@ must have the following parameters:
> >  For example in Linux fdisk, the sequence for a clear card is the following:
> >  	* o ..................... create a clear partition table
> > 
> > +	* p ..................... here you need to verify that units is set to
> > +	                          sectors. In the output, earch for a line
> > +				  containing:
> > +				      Units = sectors of 1 * 512 = 512 bytes
> > +				  If no such line is present, press "u" to
> > +				  switch units to sectors.
> > 
> >  	* n ..................... create new partition
> >  	
> >  		* p ............. primary partition
> >  		* 1 ............. first partition
> 
> Would it not make sense to actually make sure this is the case, like
> by passing the "-u" option to fdisk ?

Definitelly, please check v3 of the patch. Fabio was so kind to check my grammar 
issues etc ;-)

M