From mboxrd@z Thu Jan  1 00:00:00 1970
From: Anatolij Gustschin <agust@denx.de>
Date: Fri, 23 Dec 2011 00:21:50 +0100
Subject: [U-Boot] CPU POST on MPC5200 fails with U-Boot built using GCC 4.6.1
Message-ID: <20111223002150.7e9d387d@wker>
List-Id: <u-boot.lists.denx.de>
MIME-Version: 1.0
Content-Type: text/plain; charset="us-ascii"
Content-Transfer-Encoding: 7bit
To: u-boot@lists.denx.de

Hi,

I noticed a problem while testing Wolfgang's patch

PPC: fix "Warning: FOO uses hard float, BAR uses soft float".

U-Boot built for TQM5200 using ELDK-5.1 powerpc toolchain
seems to have issues in CPU POST test. I see similar problem
both with and also without Wolfgang's patch applied:

U-Boot 2011.12-rc3-00002-gaf44f4b (Dec 23 2011 - 00:08:10)

CPU:   MPC5200 v1.2, Core v1.1 at 396 MHz
       Bus 132 MHz, IPB 132 MHz, PCI 66 MHz
Board: TQM5200 (TQ-Components GmbH)
       on a STK52xx carrier board
I2C:   85 kHz, ready
DRAM:  64 MiB
Flash: 32 MiB
In:    serial
Out:   serial
Err:   serial
Net:   FEC
POST i2c PASSED
POST cpu Error at multi test !
FAILED
^^^^^^

IDE:   Bus 0: OK 
  Device 0: Model: 32MB CHH Firm: Rev 1.01 Ser#: 403303C48A30730031
            Type: Removable Hard Disk
            Capacity: 30.5 MB = 0.0 GB (62592 x 512)
  Device 1: not available
SRAM:  512 kB
VGA:   SMI501 (Voyager) with 8 MB
PS/2:  No device found
Kbd:   reset failed, no ACK

Type run flash_nfs to mount root filesystem over NFS

Anatolij