[U-Boot] [PATCH 2/4] net: fec_mxc: allow use with cache enabled

[Marek Vasut <marex@denx.de>]

Dear Eric Nelson,

> On 03/05/2012 08:39 AM, Marek Vasut wrote:
> > Dear Eric Nelson,
> > 
> >> On 03/04/2012 06:49 PM, Marek Vasut wrote:
> >>>> On 03/02/2012 04:39 PM, Marek Vasut wrote:
> >>>>>> +			 * Invalidate data cache over the buffer
> >>>>>> +			 */
> >>>>>> +			addr = (uint32_t)frame;
> >>>>>> +			size = roundup(frame_length,
> > 
> > CONFIG_FEC_DATA_ALIGNMENT);
> > 
> >>>>>> +			invalidate_dcache_range(addr, addr + size);
> >>>>> 
> >>>>> DTTO here, frame length might not be aligned properly, or will it be?
> >>>>> Network stack must be properly analyzed here.
> >>>> 
> >>>> The hardware won't return an unaligned value here, so this should be
> >>>> good.
> >>> 
> >>> Are you sure? You can't receive frame aligned to 8 bytes boundary?
> >> 
> >> Unless I'm missing something, received packet start addresses are
> >> defined by the driver in fec_rbd_init(), the code just modified to use
> >> memalign, so we're good here.
> > 
> > Ok, that's good then. I'll skim through this driver one more time tonight
> > and see what comes out from it.
> 
> Thanks.
> 
> I just sent V2.

I can't seem to find it, did you really send it?

Best regards,
Marek Vasut