[U-Boot] [PATCH] mx6qsabresd: Add basic support

[Wolfgang Denk <wd@denx.de>]

Dear Stefano,

In message <4F898CA5.8070308@denx.de> you wrote:
>
> The start address CONFIG_SYS_MEMTEST_START is the lowest address of the
> SDRAM that can be accessed, that is MMDC0_ARB_BASE_ADDR (0x10000000) for
> i.MX6.

But it _should_ be the lowest address that can _safely_ be used for
such tests, i. e. the range MEMTEST_START - MEMTEST_START must neither
contain the exception vectors, not U-Boot's code, stack or malloc arena.

> dynamically, also the last RAM address that can be tested should be
> computed at run time and not at compile time with CONFIG_SYS_MEMTEST_END.

CONFIG_SYS_MEMTEST_END is NOT the end of physical RAM, but the end of
the range that can be tested without crashing U-Boot...

> So I will be for a patch that changes the behavior of mtest and computes
> automatically the last testable address if the second parameter is not
> given, dropping CONFIG_SYS_MEMTEST_END - I know, this is not part of
> your patch, I have already said I can be OT ;-)

Such a patch would be wrong.


Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
"I've seen it. It's rubbish."          - Marvin the Paranoid Android