[U-Boot] [PATCH] MX5: PAD_CTL_DRV_VOT_LOW and PAD_CTL_DRV_VOT_HIGH exchanged

[David Jander <david.jander@protonic.nl>]

On Wed,  9 May 2012 12:13:04 +0200
Stefano Babic <sbabic@denx.de> wrote:

> After an update to the MX51 reference manual (Rev. 5), the
> values of the PAD_CTL_DRV_VOT_LOW and PAD_CTL_DRV_VOT_HIGH
> are now clearly wrong:
> 
> "Bit 13:
> High / Low Output Voltage Range. This bit selects the output voltage mode for
> SD2_CMD. 0 High output voltage mode
> 1 Low output voltage mode"
> 
> The values are currently negated in code - fixed.
> 
> Reported-by: David Jander <david.jander@protonic.nl>
> Signed-off-by: Stefano Babic <sbabic@denx.de>
> CC: Marek Vasut <marek.vasut@gmail.com>
> CC: David Jander <david.jander@protonic.nl>
> ---
>  arch/arm/include/asm/arch-mx5/iomux.h |    4 ++--
>  1 file changed, 2 insertions(+), 2 deletions(-)
> 
> diff --git a/arch/arm/include/asm/arch-mx5/iomux.h b/arch/arm/include/asm/arch-mx5/iomux.h
> index 760371b..e3765a3 100644
> --- a/arch/arm/include/asm/arch-mx5/iomux.h
> +++ b/arch/arm/include/asm/arch-mx5/iomux.h
> @@ -66,8 +66,8 @@ typedef enum iomux_pad_config {
>  	PAD_CTL_HYS_ENABLE = 0x1 << 8,	/* Hysteresis enabled */
>  	PAD_CTL_DDR_INPUT_CMOS = 0x0 << 9,/* DDR input CMOS */
>  	PAD_CTL_DDR_INPUT_DDR = 0x1 << 9,/* DDR input DDR */
> -	PAD_CTL_DRV_VOT_LOW = 0x0 << 13, /* Low voltage mode */
> -	PAD_CTL_DRV_VOT_HIGH = 0x1 << 13,/* High voltage mode */
> +	PAD_CTL_DRV_VOT_LOW = 0x1 << 13, /* Low voltage mode */
> +	PAD_CTL_DRV_VOT_HIGH = 0x0 << 13,/* High voltage mode */
>  } iomux_pad_config_t;
>  
>  /* various IOMUX input functions */

Acked!

thanks.

Best regards,

-- 
David Jander
Protonic Holland.