[U-Boot] [PATCH 4/7] dfu: MMC specific routines for DFU operation

[Marek Vasut <marex@denx.de>]

Dear Lukasz Majewski,

[...]

> > > > Holy Moly ... can we not make this into simple calls to those
> > > > subsystems ? Instead invoking command is crazy ;-)
> > > 
> > > Are they really simple?  There's a few other places we do this, and
> > > so long as it's documented that DFU depends on CONFIG_FAT_WRITE for
> > > writing to fat and so forth.
> > 
> > Well ain't it easier to call fat_write() or similar?
> 
> I've decided to use run_command on a purpose.
> 
> This call provides clean and reliable API. It is very unlikely that the
> mmc write <dev> <addr> <start> <size> command will change (or any
> other).
> On the other hand the fields of struct mmc are changed from time to
> time.

I'm afraid it might change with the driver model soon.

> Moreover, mmc drivers are also a subject to change (like adding dw_mmc
> recently).
> Using run_command also takes the burden of mmc_init() related calls.
> 
> Of course the run_command's downside is the speed of execution. But is
> it so important when one considers, the firmware update?

But as Stephen pointed out, the type checking is much better when used as 
function.

> Side note: DFU uses only EP0 (for transfer and configuration), so this
> is rather slow communication link.

I see

> I'm open for discussion.

Yes please, I think I started some bad flamewar in here :/

Best regards,
Marek Vasut