[U-Boot] [PATCH] at91: Add support for taskit AT91SAM9G20 boards.

[Markus Hubig <mhubig@imko.de>]

On Wed, Aug 01, 2012 at 10:21:04PM +0200, Andreas Bie?mann wrote:
> On 01.08.12 21:28, Markus Hubig wrote:
> > On Wed, Aug 01, 2012 at 11:58:22AM +0200, Andreas Bie?mann wrote:
> >>> +	/* Need to reset PHY -> 500ms reset */
> >>> +	writel(AT91_RSTC_KEY | AT91_RSTC_MR_ERSTL(13) |
> >>> +		AT91_RSTC_MR_URSTEN, &rstc->mr);
> >>
> >> Hmm ... is it OK to generate the user reset here? I know this is the
> >> same in at least at91sam9263ek, can you please check if we should
> >> instead delete that bit in MR?
> > 
> > MR? Sorry I don't get this one. Please explain a bit ...
> 
> I talked about URSTEN bit in RSTC_MR (Reset Controller Mode Register;
> p99 in at91sam9g20 datasheet). The URSTEN bit set to 1 means disable low
> level detection on NRST pin. Which in fact disables external reset with
> the reset key. One have to check if this is true or maybe I'm wrong here.

Hmm ok I'll investigate this a bit further ...

> > | 	/* avoid shutdown by watchdog */
> > | 	hw_watchdog_reset();
> 
> 	WATCHDOG_RESET();

Fixed!

> > | 	if (timeout <= 0) {
> > | 		debug("ERROR: Timeout waiting for PHY reset!\n");
> 
> Error messages should not use debug macro.

Fixed!

> For timeout stuff you could also use get_timer(0) to get current
> timestamp and compare against another timestamp.

Fixed!

Cheers, Markus