[U-Boot] [PATCH 1/6] h2200: Add support for iPAQ h2200

[Marek Vasut <marex@denx.de>]

Dear ?ukasz Da?ek,

> On 22.09.2012 20:21, Marek Vasut wrote:
> >>>>>>>> +{
> >>>>>>>> +	writel(val, addr);
> >>>>>>>> +	asm volatile("" : : : "memory");
> >>>>>>>> +	readl(addr);
> >>>>>>>> +	asm volatile("" : : : "memory");
> >>>>>>>> +}
> >>>>>>>> +
> >>>>>>>> +static void h2200_pxa2xx_dram_init(void)
> >>>>>>> 
> >>>>>>> Why do you duplicate it ?!
> >>>>>>> 
> >>>>>>> [...]
> >>>>>> 
> >>>>>> Because code in pxa2xx.c disable and then re-enable memory.
> >>>>>> And u-boot is executed from memory (1st stage bootloder
> >>>>>> copied it there).
> >>>>> 
> >>>>> So don't reinit the memory at all, just skip this whole part.
> >>>> 
> >>>> 1st stage loader doesn't init everything (for example MSC).
> >>> 
> >>> So I checked ... every board calls the dram init on it's own in
> >>> dram_init() ... so just don't do that.
> >> 
> >> Do what? Don't call modified pxa2xx_dram_init?
> > 
> > What exactly do you need to do ? What registers do you need to set ? How
> > come the bootloader kick dram in, but won't configure MSC ?
> > 
> > Split out the MSC config and memory config maybe ?
> 
> Ok, I will rewrite that.

Just pull it out, but make sure you don't break the other boards ... 

> ?ukasz Da?ek

Best regards,
Marek Vasut