[U-Boot] [PATCH 08/10] split AU1X00 specific code from cmd_ide.c

Pavel Herrmann
2012-10-09T13:35:03Z

On Monday 08 of October 2012 16:38:46 Tom Rini wrote:
> On Sun, Oct 07, 2012 at 05:56:12PM +0200, Pavel Herrmann wrote:
> > Move special case of ide_swap_read() for AU1X00 SoC into SoC-specific
> > directory.
> >
> > Signed-off-by: Pavel Herrmann <morpheus.ibis@gmail.com>
>
> Two problems:
> > diff --git a/arch/mips/cpu/mips32/au1x00/au1x00_ide.c
> > b/arch/mips/cpu/mips32/au1x00/au1x00_ide.c
> [snip]
>
> > +#ifndef CONFIG_GTH2 /* GTH2 board behaves as it should */
> > +void ide_input_swap_data(int dev, ulong *sect_buf, int words)
> > +{
> > + ide_input_data(dev, sect_buf, words);
> > +}
> > +
> > diff --git a/common/cmd_ide.c b/common/cmd_ide.c
>
> That won't compile :)

sorry, my bad, i only compile tested on ppc, this is missing a header and
endif

> Second, re-base on top of next where the gth2 board is gone, this will
> make things simpiler.

done, will send V2 after MAKEALL -a powerpc finishes, just to be sure

cheers
Pavel Herrmann