[U-Boot] [PATCH v2 06/21] pmic: Enable power_board_init() support at TRATS

[Lukasz Majewski <l.majewski@samsung.com>]

Hi Stefano,

> On 05/10/2012 10:16, Lukasz Majewski wrote:
> > Enable support for power_board_init() method at TRATS board.
> > 
> > Signed-off-by: Lukasz Majewski <l.majewski@samsung.com>
> > Signed-off-by: Kyungmin Park <kyungmin.park@samsung.com>
> > ---
> > Changes for v2:
> > - None
> > ---
> >  board/samsung/trats/trats.c |   15 +++++++++++----
> >  include/configs/trats.h     |    1 +
> >  2 files changed, 12 insertions(+), 4 deletions(-)
> > 
> > diff --git a/board/samsung/trats/trats.c
> > b/board/samsung/trats/trats.c index 80ec4ad..0285668 100644
> > --- a/board/samsung/trats/trats.c
> > +++ b/board/samsung/trats/trats.c
> > @@ -68,10 +68,6 @@ int board_init(void)
> >  	check_hw_revision();
> >  	printf("HW Revision:\t0x%x\n", board_rev);
> >  
> > -#if defined(CONFIG_PMIC)
> > -	pmic_init(I2C_5);
> > -#endif
> > -
> >  	return 0;
> >  }
> >  
> 
> 
> > @@ -90,6 +86,17 @@ void i2c_init_board(void)
> >  	s5p_gpio_direction_output(&gpio2->y4, 1, 1);
> >  }
> >  
> > +#ifdef CONFIG_POWER_INIT
> > +int power_board_init(void)
> > +{
> > +
> > +#ifdef CONFIG_PMIC
> > +	pmic_init(I2C_5);
> > +#endif
> > +	return 0;
> > +}
> > +#endif
> > +
> 
> This enforces my comment in previous patch. We have two CONFIG_
> options, both must be turned on. So at least one is redundant.IMHO
> you can drop both of them if power_board_init() is declared weak.

I can define power_board_init() as __weak if you are OK with this :-).
In this case for sure CONFIG_POWER_INIT could be removed. 

I agree that CONFIG_PMIC can be removed from this piece of code. 

> 
> Best regards,
> Stefano Babic
> 



-- 
Best regards,

Lukasz Majewski

Samsung Poland R&D Center | Linux Platform Group