From mboxrd@z Thu Jan 1 00:00:00 1970 From: RgC Date: Thu, 25 Oct 2012 22:26:13 +0900 Subject: [U-Boot] USB detection In-Reply-To: <1351167718.2582.10.camel@Manukumar> References: <1337677828.2382.30.camel@Manukumar> <20120705134543.134da313@aari01-12> <1341823669.3686.30.camel@Manukumar> <201207100417.04905.marek.vasut@gmail.com> <1342073441.6917.4.camel@Manukumar> <1351167718.2582.10.camel@Manukumar> Message-ID: <20121025132613.GA306@crg> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Truncated CCs Hi, On 2012.10/25, Manukumar wrote: > Dear All > > While board bring up in custom board > iam getting below mentioned error > > I2C: ready > DRAM: DDR: failed to read SPD from address It seems you are using a DIMM for your memory (as opposed to directly soldered on the board). Simply put, DDR DIMMs have a small EEPROM which contains data about the device. You access the SPD EEPROM via an I2C address. If the DIMM detection code talks to this address and does not detect correct data, then you have the problem you are encountering. Since you are using a custom board, you should read your specs or ask your HW people about the correct SPD address. > > I googled it but i am un able to rectify it.. > Please resole ASAP > manukumar > All the best, RgC -------------- next part -------------- A non-text attachment was scrubbed... Name: not available Type: application/pgp-signature Size: 487 bytes Desc: not available URL: