[U-Boot] [PATCH] ns16550: allow UART address to be set dynamically

[Wolfgang Denk <wd@denx.de>]

Dear Stephen Warren,

In message <50CA3E7A.8020407@wwwdotorg.org> you wrote:
>
> >> My intent is that ODMDATA will definitely only be used for the console
> >> UART, and will NOT be used for anything else like LCD, RTC, ... Those
> >> other devices will certainly be configured via device tree.
> > 
> > We've been there before, you know.
> 
> I'm not quite sure what the implication is here.

What I mean is: there have been a number of times before when we
decided to do something more or less ugly because it appeared to be
the easiest / fastest / most simple approacht at that time,and we were
sure we would it need for this one special case only.  Then it gor
reused, and again, and it spread...

> > OK - what is the scope of visibility of such code?  Will it be
> > strictly board specific only?  Or SoC specific? Arch? Global?
> 
> It's partially SoC-specific, partially global.

Which exact parts would be global?

I am aware that the capability to set the UART is obviously part of
the global code.

But the actual implementation of such setting would be not global at
all, right?

> Note that by "all" and "global" here, I'm talking relative to all Tegra
> SoCs, not about anything non-Tegra. "SoC-specific" means different for
> Tegra20, Tegra30, Tegra114, etc.

OK.

> Note that in the latter case, I haven't pushed out the patches which
> document the UART pinmux fields yet, but will very soon; most likely as
> soon as we've resolved this conversation.

You guarantee that this all will remain strictly within Tegra specific
areas, only?  And only for the UART?

Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
"The whole world is about three drinks behind."     - Humphrey Bogart