[U-Boot] [PATCH] ns16550: allow UART address to be set dynamically

[Wolfgang Denk <wd@denx.de>]

Dear Stephen Warren,

In message <50CF9BAA.3050504@wwwdotorg.org> you wrote:
>
> There are many ways besides device tree to enumerate hardware. For
> example, consider PCI or USB (albeit USB isn't memory mapped). I don't

Yes, there are.  But your console port cannot be compred against
dynamically populated and scannable bus interfaces like USB or PCI,
and I think you are aware of that.

> think we should tie any new U-Boot dynamic device registration API to
> device tree, since that would seem to prevent (or imply against) usage
> of that API with PCI for example.

Not any dynamic device registration.  But here, it actually AIN'T
dynamic - it is fully static, just board dependent.

> Perhaps this is just bike-shedding over naming?

No.

> So that all of the following cases could call that:
> 
> * DT parsing.
> * PCI device enumeration.
> * ODMDATA parsing.

NAK.  This is totally wrong.  ODMDATA is just a different
representation of information that could as well be encoded in a DT.
PCI or USB bus scanning gives information which cannot be encoded in a
DT passed to U-Boot (at least not unless you dynamically generate that
DT using some other softeware performing such a bus scan).

Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
If you hear an onion ring, answer it.