[U-Boot] [PATCH v5 2/2] board: add support for amcore board

[Angelo Dureghello <sysamfw@gmail.com>]

Dear Wolfgang,

thanks for the review, 

On Fri, Jan 25, 2013 at 01:30:54PM +0100, Wolfgang Denk wrote:
> Dear Angelo Dureghello,
> 
> In message <20130125104307.GA3223@sion.sysam> you wrote:
> > Add support for Sysam AMCORE mcf5307 (coldfire) based board.
> 
> Sorry for the late catch - this escaped me so far...
> 
> > Changes for v5:
> > - Fix MAINTAINERS bad sorted entry
> > - Fix incorrect indentation
> > - Remove #undef where not needed
> 
> Did you? I still see some...
> 
> > +#if defined(CONFIG_SYS_DRAM_TEST)
> > +/* memory test */
> > +int testdram(void)
> ...
> > +#endif
> 
> This is:
> 
> 1) dead code, as you don't define CONFIG_SYS_DRAM_TEST
> 2) an obsolete approach that you should not use.  We have a several
>    different (and much more reliable) memory tests already - if yuou
>    really need one, then please use the existing code.  On the other
>    hand, you are using get_ram_size, which already includes a simple
>    memory test - so re you sure you really need an extra test?
> 
> 
> > +#undef	CONFIG_SYS_DRAM_TEST		/* default undef */
> 

I used the sdram test for some help when soldering here the prototypes. 
Then i disabled the test. As you already asked me, i removed my own
sdram test function and used one already used from other boards, and
added this in the amcore.c top coments.

 * Copy memory testdram() from sandburst/common/sb_common.c

Anyway, as you said, get_ram_size is enough for me. I will remove
CONFIG_SYS_DRAM_TEST and so "int testdram(void)" content.


> ==> remove.
> 
> > +/* bypass PLL for test purpose */
> > +#undef	CONFIG_SYS_PLL_BYPASS
> 
> ???
> 

I apologize, forget out, fixed.

If you haven't seen anything else, i'll post next V6 shortly.

Best Regards,
Angelo Dureghello