* [U-Boot] oxnas810 (eTrayz) u-Boot 1.1.2 usb support
[not found] <CAEHe=Q5zsdnWaLz8_HZTLnxdes1P0ZA71GCU4RonTJKs8sa6eg@mail.gmail.com>
@ 2013-02-13 14:35 ` Marek Vasut
0 siblings, 0 replies; only message in thread
From: Marek Vasut @ 2013-02-13 14:35 UTC (permalink / raw)
To: u-boot
Dear Frank van der Jagt,
This question shall go to the ML.
> Hi,
>
> I'm trying to get usb support going for eTrayz nas (oxnas810 device).
> http://www.plxtech.com/products/consumer/oxe810dse
> This device uses u-Boot 1.1.2 to boot from NOR flash.
>
> I have following questions:
>
> - Why hasn't the source of the oxnas810 drivers been published to the
> u-Boot 1.1.2 tree. If I look there there are no drivers for the board in
> the source tree.
> Was PLX Tech not obliged to do so under the open source licence ?
The source must be published under the terms of GPL, not commited upstream.
> - Where can I get hold of the u-Boot 1.1.2 driver source for this device
> and was usb support implemented for this board ?
Ask your hardware vendor.
> Thanks and rgds,
> Frank Hunter
> intraxit
Best regards,
Marek Vasut
^ permalink raw reply [flat|nested] only message in thread
only message in thread, other threads:[~2013-02-13 14:35 UTC | newest]
Thread overview: (only message) (download: mbox.gz follow: Atom feed
-- links below jump to the message on this page --
[not found] <CAEHe=Q5zsdnWaLz8_HZTLnxdes1P0ZA71GCU4RonTJKs8sa6eg@mail.gmail.com>
2013-02-13 14:35 ` [U-Boot] oxnas810 (eTrayz) u-Boot 1.1.2 usb support Marek Vasut
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox