[U-Boot] [PATCH 2/2] ARM: highbank: remove DRAM bank setup

[Wolfgang Denk <wd@denx.de>]

Dear Rob Herring,

In message <1359085160-28675-2-git-send-email-robherring2@gmail.com> you wrote:
>
> The memory sizes in highbank dtb's are already correct, so remove the DRAM
> bank setup so the memory node is not fixed up by u-boot.

I think you do more here...

> -void dram_init_banksize(void)
> -{
> -	gd->bd->bi_dram[0].start = CONFIG_SYS_SDRAM_BASE;
> -	gd->bd->bi_dram[0].size =  PHYS_SDRAM_1_SIZE;
> -}
...
> -#define CONFIG_NR_DRAM_BANKS		1
> +#define CONFIG_NR_DRAM_BANKS		0

I think this is a very bad idea, as you will now be no longer possible
to get information about memory sizes from U-Boot.  For exmaple,
"bdinfo" will not print any reasonable value any more.

Please don't do that!

Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
Ever try. Ever fail. No matter. Try again. Fail again.  Fail  better.
                                                        -- S. Beckett