[U-Boot] [PATCH 14/23] powerpc/t4240qds: Add voltage ID support

[Wolfgang Denk <wd@denx.de>]

Dear York Sun,

In message <1363972531-25641-14-git-send-email-yorksun@freescale.com> you wrote:
> T4240 has voltage ID fuse. Read the fuse and configure the voltage
> correctly. Core voltage has higher tolerance on over side than below.
> 
> Signed-off-by: York Sun <yorksun@freescale.com>
> ---
>  board/freescale/t4qds/t4qds.c |  230 +++++++++++++++++++++++++++++++++++++++++
>  include/configs/t4qds.h       |   12 ++-
>  2 files changed, 240 insertions(+), 2 deletions(-)

CHECK: Alignment should match open parenthesis
#301: FILE: board/freescale/t4qds/t4qds.c:314:
+       debug("VID: Current vid setting is (0x%x) %d mV\n",
+               vid_current, vdd_current/100);

WARNING: quoted string split across lines
#310: FILE: board/freescale/t4qds/t4qds.c:323:
+               printf("VID: Could not read voltage sensor "
+                       "abort VID adjustment\n");



Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
"Open the pod bay doors, HAL."                    - Dave Bowman, 2001