[U-Boot] [PATCH v3] usb: omap: ulpi: fix ulpi transceiver access

[Marek Vasut <marex@denx.de>]

Dear Michael Trimarchi,

> Dear Marek
> 
> On 06/09/2013 10:05 PM, Marek Vasut wrote:
> > Dear Michael Trimarchi,
> > 
> >> This patch fix the omap access to the transceiver
> >> configuration registers using the ulpi bus. As reported by
> >> the documentation the bit31 is used only to check if the
> >> transaction is done or still running and the reading and
> >> writing operation have different offset and have different
> >> values. What we need to do at the end of a transaction is
> >> leave the bus in done state. Anyway an error using the ulpi
> >> omap register is not recoverable so any error give out the
> >> usage of this interface.
> >> 
> >> Signed-off-by: Michael Trimarchi <michael@amarulasolutions.com>
> >> Reviewed-by: Igor Grinberg <grinberg@compulab.co.il>
> > 
> > Tom, can you ACK/NAK this ? I have no omap board.
> 
> I don't understand the point, the old code was wrong and you can
> check omap3/omap4 documentation. If you revert it you still have a wrong
> code so it's better to drop omap3/4 viewport.
> 
> You can take a look at this patch
> 
> http://git.omapzoom.org/?p=kernel/omap.git;a=commitdiff;h=2a18e1248588c326f
> 0a63c5bce4a611d709130a8
> 
> that is used to fix this errata
> 
> http://git.omapzoom.org/?p=kernel/omap.git;a=commitdiff;h=a0dd0ee69578e32f1
> 469596b8fd3a6c8ef172d42
> 
> I'm using this ulpi code in one of our device. I have fixed the u-boot
> viewport code because I have seen it wrong. Sorry for the late response
> but I was busy for a Wedding ;)

Fear not! I'm busy having no life, it's really hard task! I will actually be 
busy with that until sometimes mid-next-week.

> I can try to test it tomorrow on an omap3
> device but I think that is more easy for Stefano because he has already a
> platform with a recent uboot

I don't care who tests it, I'd just like to make sure it's tested on more 
devices than one ;-)

Best regards,
Marek Vasut