[U-Boot] [PATCH] mtd: mxc_nand: Fix crash after MTD resync

[Marek Vasut <marex@denx.de>]

Dear Scott Wood,

> On 07/02/2013 10:11:55 AM, Marek Vasut wrote:
> > The driver triggered a BUG() in nand_base.c:3214/nand_scan_tail()
> > because the ecc.strength was incorrectly set in case of NAND_ECC_HW
> > instead of NAND_ECC_HW_SYNDROME ECC mode.
> > 
> > Signed-off-by: Marek Vasut <marex@denx.de>
> > Cc: Beno?t Th?baudeau <benoit.thebaudeau@advansee.com>
> > Cc: Fabio Estevam <fabio.estevam@freescale.com>
> > Cc: Scott Wood <scottwood@freescale.com>
> > ---
> > 
> >  drivers/mtd/nand/mxc_nand.c |    7 ++-----
> >  1 file changed, 2 insertions(+), 5 deletions(-)
> > 
> > diff --git a/drivers/mtd/nand/mxc_nand.c b/drivers/mtd/nand/mxc_nand.c
> > index ac435f2..08c7b8b 100644
> > --- a/drivers/mtd/nand/mxc_nand.c
> > +++ b/drivers/mtd/nand/mxc_nand.c
> > @@ -1238,15 +1238,12 @@ int board_nand_init(struct nand_chip *this)
> > 
> >  		this->ecc.write_oob = mxc_nand_write_oob_syndrome;
> >  		this->ecc.bytes = 9;
> >  		this->ecc.prepad = 7;
> > 
> > -	} else {
> > -		this->ecc.mode = NAND_ECC_HW;
> > -	}
> > -
> > -	if (this->ecc.mode == NAND_ECC_HW) {
> > 
> >  		if (is_mxc_nfc_1())
> >  		
> >  			this->ecc.strength = 1;
> >  		
> >  		else
> >  		
> >  			this->ecc.strength = 4;
> > 
> > +	} else {
> > +		this->ecc.mode = NAND_ECC_HW;
> > 
> >  	}
> 
> Where does ecc.strength now get set for the non-SYNDROME case?

Gone ;-) The strength only needs to be set for the SYNDROME case according to 
the code in nand_base.c .

Best regards,
Marek Vasut